Standard non-tamper evident label material:
PolyAsset:- – Extra Durable Asset Labels: Platinum (metallic/aluminium) orWhite semi-gloss finished polyester Mylar. A rugged, durable labels, using a permanent adhesive as well as being the most popular for fixed asset tags/labels.
Available in two sizes either 1.7/8″ x 3/4″ (47mm x 19mm) or 1″ x 1/2″ (25mm x 12.5mm).
With the PolyAsset labels we are able to print in Blue, Red and Black on to these labels.
Please note: Red print cannot be used with a barcode.
——————————————————————-
Tamper evident label materials:
PolyCheck:- Available in Platinum (matte aluminium surface) as a new material, or original Chrome, Polyester (Mylar) with a permanent acrylic adhesive. In the event of removal of the label the hidden graphic checker-board pattern is left on the surface of the item it was attached to. Any attempt to re-position the removed label exactly where it was lifted from still shows the label was tampered with. The adhesive needs to cure at room temperature for 36 hours before it cures completely and may not be suitable for some low grade plastics, however, on bare or painted metal as well as most clean, smooth surfaces these security seals will stand up to rough handling and last for years! Due to the metallic foil backing these labels must be considered conductive to electricity and appropriate precautions taken. The hard smooth surface of these seals can be written on with special pens such as for marking the surface of CDs. (easily available from most Office Supply Companies).
Available in two sizes either 1.7/8″ x 3/4″ (47mm x 19mm) or 1″ x 1/2″ (25mm x 12.5mm).
Please note: The Chrome PolyCheck label cannot be printed with a barcode. The surface is too reflective.
PolyVOID:- White tamper evident label or Platinum( aluminium look surface), which leaves a “VOID” message on label and surface if lifted! This tamper evident label / seal can also be used as barcode labels, you can write on it with a permanent CD marker pen .
These labels are ONLY Available in 7/8″ x 3/4″ (47mm x 19mm) due to the word void graphic
and can only be printed in Black or Red ink.
PolyBreak:– White Semi-gloss polyester Destructible:
This material looks very similar to PTFE tape used by plumbers to seal pipe joints, however, the difference is our PolyBreak uses the finest membrane you can possibly get and is extremely sensitive to unauthorized entry.
This label material has a very aggressive adhesive which will adhere to just about everything and anything, easily breaking into tiny fragments at any attempted removal. It is an ideal tamper evident label provided you do not require abrasion resistance. PolyBreak material is outdoor rated Waterproof and but due to is non-abrasive nature has a lower outdoor life expectancy than our other polyester (Mylar) material. Should you require this type of label and its qualities for use in an area where they are subject to abrasion, scuffing and general wear a tear, we can offer to supply our clear over-laminate which is used to protect the label. This acts as a barrier against wear and tear as well as moisture.
Available again in two sizes either 1.7/8″ x 3/4″ (47mm x 19mm) or 1″ x 1/2″ (25mm x 12.5mm).
